what am i doing wrong?
and how to do this properly?
Well, for a start I don’t know about these values you set for left and top.
I’m not all too sure what the rest of the process in your PG is supposed to do. I believe you know 
In any case, setting values for top and left (in pixels or percentage) or I believe using any from the supported values would make it work.
3 Likes
was busy putting a custom slider in hahahaha
… sometimes …
thank you so much for looking into it … AGAIN!
2 Likes
You’re always welcome here. I guess you know that 
Have a good one 
2 Likes